1OWNERS MANUAL Handheld Drill MODEL: HHD323 FORM <<HHD323 rev 10/2009
10• For Additional Safety Use A Ground Fault-Interrupter (GFCI ) Device. • Do Not Use The Drill In Inflammable, Gaseous, Or Explosive Atmosphere
112. Placing one wrench on the machined flats of the output shaft and one wrench on the end adapter of the core bit tighten the bit on the spindle.
123. Slowly guide the bit into the hole so that there is no skidding or movement of the drill. The entire circumference of the core bit should pen
131. Start The Drill At 45° To The Work Surface With The Bit About 1/2” From The Work Surface. The Drill Must Be Running At Full Speed Before The
14If Steel Is To Be Drilled Use The Lowest Speed And Reduce Feed Pressure When drilling by hand use a drill bit that is has a bond that is one (1)
15IV. PARTS LIST SECTION A. Ordering Information 1. List model number and serial number of machine. 2. List part number and serial number of par
1619202122232625243034333639404445474142434849272935313221611817624567891011121314151654525350515556576051-158593727384662-1272816-116-13 B. HHD323
17C. HHD323 Parts Listing Item DESCRIPTION Qty Part No 1 GEAR CASE HHD323 1 244004 2 SPINDLE HHD323 1 244005 3 OIL SEAL 32D 22d DOUBLE LIP SEAL
18 C. HHD323 Parts Listing Item DESCRIPTION Qty Part No 38 WASHER M5 DIN125 FLAT 4 235065 39 ARM BASE TELESCOPIC HHD323 1 244037 40 SCR 5/32”-16
2WARRANTY Norton warrants all products manufactured by it against defects in workmanship or materials for a period of one (1) year from the date of
Saint-Gobain Abrasives 2770 West Washington Stephenville, TX 76401 Phone: 800-554-8003 Fax: 800-443-1092
3Table Of Contents CONTENTS PAGEI. Preparation A. Safety Precautions 4-6B. Assembly 7C. Specifications 7D. Electrical Supply 8-10F. Genera
4I. PREPARATION A. Safety Precautions Important! The following safety precautions must always be observed. Hazard Symbols Fuel (gasoline) is ext
5 Dust and Silica Warning Grinding/cutting/drilling of masonry, concrete, metal and other materials can generate dust, mists and fumes containing
6 1. Know your drilling machine! Read the Owner’s manual carefully. Learn the operation, application and limitations, as well as the specific pot
7I. PREPARATION B. Assembly The HHD323 handheld drill is shipped completely assembled except for core bit adapters, core bit, and the collar handl
8D. Electrical Supply The HHD323 handheld drill is furnished with a 115 volt, single phase motor. This motor operates within a power range of 110
9The installation of cables, plugs, and switches must be made ONLY by an authorized electrician. All installations must be made according to the lo
Comments to this Manuals